Fits: 2019-2026 Chevrolet Silverado 1500 and 2020-2023 Silverado 2500HD / 3500HD.
Required Tools
T15 Torx wrench or bit
Step 1: Remove Mounting Screws
Open the tailgate and locate the two T15 Torx screws on the inner side of the tail light. Carefully unscrew them.
Step 2: Pull Out the Tail Light Housing
Firmly grasp the tail light and pull it straight back towards you to release it from the body clips.
Step 3: Disconnect Secondary Plugs
If your truck is equipped with bed lights, press the release tab to unplug the small connector behind the light.
Step 4: Disconnect the Main Harness Connector
Go underneath the truck and locate the main connector. Slide the red locking tab back, press the release clip, and pull to disconnect.
Step 5: Feed the New Harness
Take your new LED tail light and feed the main wiring harness through the body opening down towards the ground.
Step 6: Reconnect Secondary Connectors
Connect the small plug for the bed light (if applicable) and make sure it clicks and locks into place.
Step 7: Mount the New Housing
Line up the alignment pins on the new tail light with the holes in the truck body. Push the housing firmly forward into place.
Step 8: Secure with Screws
Re-install the two T15 Torx screws to secure the new tail light to the body.
Step 9: Lock the Main Harness Connector Underneath
From underneath the truck, plug the main harness back in. Slide the red locking tab forward to secure the connection.
Step 10: Test Functionality
Before finishing, test the turn signals, brake lights, and reverse lights to make sure every connection is secure.
Shop LED Lights for Your Silverado
See all PrismBeam LED lights for the 2019-2026 Silverado 1500 and 2020-2023 2500HD / 3500HD
