Every PrismBeam headlight and tail light is a complete LED assembly that replaces your factory lamp — not a bulb swap. Whatever you drive, each one is built to the same six standards.
A New Look, Day and Night
Most owners upgrade for the look: a new housing, a signature light line, and a finish that reads as factory-intended rather than bolted on. Many of our assemblies add a sequential turn signal and a startup animation that runs when you turn the car on.
Good to know: sequential signals and startup animations vary by model. Each product page lists what that assembly does.
Made for Your Exact Model
Each assembly is built for a specific vehicle generation and mounts to the factory points, so it sits in the opening the way your original lamp did. The vehicle selector at the top of our site takes you straight to the lights for your year, make and model.
Good to know: some vehicles changed lamps partway through a generation, or differ by trim or factory lighting package. Each product page lists the versions that assembly fits and the ones it doesn't — check it before you order.
Plug-and-Play Install
Our assemblies connect to your factory plugs: no cutting, no splicing, nothing to solder. Where a vehicle's factory connector differs from the assembly, the adapter harness ships in the box.
Step-by-step guides for many vehicles are in our Installation Guides.
Works With Your Car's Electronics
LEDs draw less power than factory bulbs, and many modern cars read that difference as a burned-out bulb. Our assemblies have CANbus decoders built in, so on most vehicles you get no flicker, no hyperflash and no dashboard warnings — without adding resistors or relays.
Good to know: a small number of vehicles still need an extra error-canceling module, including cars with factory adaptive driving beam (ADB) headlights. If a warning appears after installation, contact us.
Brighter and Street-Ready
Our LED headlights put out at least 3× the light of stock halogen bulbs, with a sharp cutoff that keeps the light on the road instead of in oncoming drivers' eyes. Every assembly carries DOT/SAE markings.
Good to know: the headlights can be aimed after installation — the adjusters are on the back of the housing. Aim them once they're in, as you would any new headlight.
Built to Last
A pressure-equalizing vent lets the housing breathe, so it clears on its own after cold mornings and car washes instead of trapping moisture. The LEDs are independently lab-tested, and every assembly is covered by a 2-year warranty.
Returns are accepted within 30 days. See Returns & Warranty for details.
