Skip to content
2022-2026 Honda Civic Hatchback & 2023-2026 Type R LED Tail Lights Installation Guide

2022-2026 Honda Civic Hatchback & 2023-2026 Type R LED Tail Lights Installation Guide

Fits: 2022-2026 Honda Civic 11th generation hatchback and 2023-2026 Civic Type R. The sedan uses different tail lights.

This set replaces the center light on the hatch and the outer lamps on the body.

Required Tools

  • Ratchet and 8mm socket (an extension helps)
  • Plastic trim removal tool
  • Fish tape or stiff wire, for routing the harness through the rubber grommet
  • Zip ties
  • Masking tape (optional, to protect the paint)

Tools for Honda Civic 11th gen hatchback tail light installation

Part 1: Preparation and Removal

Step 1: Remove the Hatch Trim

Open the hatch. Use a trim tool to pop off the upper center trim piece, then remove the lower trim panel around the grab handle to expose the center light mounting points.

Step 1: remove the upper center trimStep 1: remove the lower trim panel

Step 2: Remove the Factory Center Light

Remove the 8mm nuts securing the factory center light bar. Disconnect the plug and carefully pull the light away from the hatch.

Step 2: remove the center light nutsStep 2: remove the center light

Step 3: Remove the Outer Tail Lights

Remove the two 8mm bolts securing each outer tail light. Pull the light firmly straight back to release the clips. Do not pull it sideways.

Step 3: remove the outer tail light boltsStep 3: pull the outer tail light straight back

Part 2: Wiring and Installation

Step 4: Route the Harness Through the Grommet

Run the included connection harness from the body to the hatch. Use a stiff guide wire to feed it through the factory rubber grommet so the seal stays watertight. Do not cut the grommet.

Tip: a little soapy water or silicone spray on the harness helps it slide through the grommet.

Step 4: feed the harness with a guide wireStep 4: harness through the rubber grommet

Step 5: Install the New Outer Lights

Connect the factory plug to the new outer tail light, line up the guide pins, push the light into place and reinstall the two 8mm bolts.

Step 5: connect the outer lightStep 5: line up the guide pinsStep 5: reinstall the bolts

Step 6: Connect and Install the Center Light

Connect the harness you routed to the new center light, then secure the center light to the hatch with the factory nuts.

Step 6: connect the center lightStep 6: install the center light

Step 7: Test and Reassemble

Test the brake, turn signal and reverse lights on both sides. Tidy the harness with zip ties, then reinstall the hatch trim.

Common Issues and Solutions

Tail light does not turn on after installation. Check that the harness connectors are fully seated. Inspect the pins inside each connector; if any are bent, carefully straighten them with a small precision tool and reconnect securely.

Swap test. If a tail light still does not work, swap the left and right units to find out whether the issue is the light itself or the vehicle wiring.

Condensation inside the tail light. Temperature differences can cause light condensation, which is normal. Once the light has been on for a while and the internal temperature stabilizes, the moisture clears on its own. It does not affect brightness, performance, or lifespan.

PrismBeam LED tail lights on a Honda Civic 11th gen hatchback

Shop LED Lights for Your Civic

See all PrismBeam LED lights for the 2022-2026 Honda Civic Hatchback and Type R

Cart 0

Your cart is currently empty.

Start Shopping